Cleaned out Dad’s garage and Ham shack. This was plugged in and works. It comes with powercord and mics as shown. I hope you enjoy it! Description from internet Sources. The Kenwood TS-940S is a serious radio for the serious operator. Superb interference reduction circuits and high dynamic range receiver combine with superior transmitter design to get your signal through. This all mode transceiver covers 160 to 10 meters with a general coverage receiver. Other refinements include: SSB slope tuning, CW VBT (variable bandwidth tuning), IF Notch, Audio Filter, Dual Mode NB, All-mode Squelch, RF Attenuator, Switchable AGC (Off/Fast/Slow), Full QSK, Speech Processor, Dual digital VFOs, 40 memories, Scan. Large fluorescent display and. The TS-940S operates from 120 VAC. Unlike its hybrid predecessors, the Kenwood TS-940S is an all solid state HF transceiver with an optional built in automatic antenna tuner (AT). It transmits on the amateur radio bands from 160 to 10 meters including the WARC bands and is also a general coverage receiver from 150 kHz to 30 MHz. Produced starting in 1985, it remains extremely popular with serious amateur operators because of its many microprocessor controlled features and superior on-the-air performance. It is representative of Kenwood’s all solid state transceivers in the 4xx and 9xx series models. Computer interface software is available for the TS-940S. A typical TS-940S transceiver will actually output 150 watts or more in CW mode, but CW power output should be held to no more than 110 Watts. The extra 1.4 dB (a needle width on your contacts S-meter) is not worth the risk of damaging the final transistors. SSB peak envelope power will exceed that, of course, with no ill effect so long as the average power is kept to about 100 Watts. While alignment of the TS-940S is tedious and requires lab quality test equipment, once properly aligned it will operate reliably for years if treated with respect. TX: 10-160 m + WARC RX: 0.15-30 MHz. 40 regular in 4 banks 4 program scan pairs. No dedicated, use VFO A/B split instead. Mains: 120 / 220 / 240 VAC. RX: 80 W TX: Max 510 W. 50 ohms (20-150 ohms with AT-940) / SO-239. 401141350 mm (15.795.5513.78). 18.5 Kg (40.79 lbs) 20 Kg (44.1 lbs), with AT-940. 24 hr clock and timer. Triple conversion superheterodyne (FM). 0.15-0.5 MHz: 10 uV 0.5-1.8 MHz:? UV 1.8-30 MHz: 2 uV FM (12 dB SINAD) 0.5-1.8 MHz: 32 uV 1.8-30 MHz: 0.5 uV SSB/CW/FSK (10 dB S/N) 0.15-0.5 MHz: 1 uV 0.5-1.8 MHz: 4 uV 1.8-30 MHz: 0.2 uV. 80 dB (1.8-30 MHz). 1.5 W at 10% distortion / 8 ohms. 3.5 mm, 8 ohms. 500 ohms to 50 kohm / 8-pin. The item “Kenwood TS-940S Amateur/ Ham radio” is in sale since Sunday, August 11, 2019. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The seller is “rangerdawg1″ and is located in Carp Lake, Michigan. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, Sweden, South Korea, Taiwan, South africa, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, New Zealand, Singapore, Switzerland, Norway, Qatar, Croatia, Antigua and barbuda, Dominica, Grenada, Saint lucia, Barbados, Bermuda, Bolivia, Iceland, Jordan, Liechtenstein, Sri lanka, Luxembourg, Martinique, Maldives, Nicaragua, Oman, Paraguay, Uruguay.
- Model: TS-940S
- Band: HF
- Brand: Kenwood