I opened package and powered unit up to make sure it is operational. I can attest to the fact that the box and plastic bags inside were unopened and it was stored in a dry location. Plastic still over screen and unit looks to be in flawless condition. Box may show some signs of wear but not much. The FT-897D is a rugged, innovative, multiband, multimode portable transceiver for the amateur radio MF/HF/VHF/UHF bands. The new FT-897″D” version includes coverage of the U. 60-meter (5 MHz) band, along with the 0.5 ppm TCXO Unit, at no additional charge! The bottom side of the FT-897 contains a power source tray which can accommodate up to two of the optional 13.2 Volt, 4500 mAh FNB-78 Ni-MH Battery Packs, for completely portable operation without any external power source. Maximum power output is 20 Watts (all bands) during battery operation, and with two FNB-78s you may expect up to eight hours of operating time (TX 5%, RX 5%, standby 90%). Whats more, you can charge one of the FNB-78 Battery Packs while operating the FT-897 off the other packideal for situations where solar or other power sources are available. The optional CD-24 Charge Adapter provides the necessary voltage for charging, and it may be used in conjunction with an external 13.8 Volt source, or the optional PA-26 AC Adapter may be used to power the CD. Mobile operation, using the FT-897 as the cornerstone, is pure joy! The combination of the FT-897 and the ATAS-120 Auto-Tune Antenna System provides automated operation from HF through the UHF spectrum! Using an external 13.8 Volt power source, you get a full 100 Watts of power output on HF and six meters 144 MHz: 50 W, 430 MHz: 20. The FT-897s outstanding fundamental performance invites expansion into a full-featured base station. The optional FP-30 Internal Power Supply provides operation from AC sources, and the clamp-on FC-30 Automatic Antenna Tuner option expands the impedance range of the transceiver. Round out your station with the MD-200A8X Deluxe Desk Microphone and the VL-1000 Quadra System Linear Amplifier for world-class performance at home! The power source tray of the FT-897 is designed to accommodate the optional FP-30 Internal Power Supply, allowing full-power operation from 100-120 V or 200-240 V AC power sources. The quiet switching-regulator design of the FP-30 is tolerant of AC input voltage variations, making it ideal for DX-pedition use! And to extend the impedance bandwidth of your antenna system, the innovative FC-30 Automatic Antenna Tuner option clamps onto the left side of the FT-897 in seco. Achieving 100 Watts of power output from such a compact package is a difficult mechanical and electrical engineering task. On HF, push-pull 2SC5125 Bipolar transistors driven by push-pull 2SK2975s provide the 100-Watt power capability, while on VHF maximum efficiency during battery operation is yielded by 2SC3102 bipolar PA transistors. The rugged aluminum die-cast chassis provides a solid foundation for the heat sink for the power amplifier, with a total of almost 40 cubic inches of heat sink surface area available. With its thermostatically-controlled twin cooling fans, the FT-897 will stand up to the rigors of DX-pedition or home contest use, with dissipation capability to spar. The FT-897 includes a wide array of analog and DSP filters to help you dig out those weak DX signals on a crowded band! One-touch activation of the DSP filters, plus a convenient DSP LED on the front panel, enhance the ease of using the DSP. DSP Bandpass Filters, Noise Reduction, a nd Auto-Notch Filter circuits are include. A wide array of features are tailored to the CW enthusiast operating from home or on an expedition! Included are a CW Tuning indicator, CW Pitch control, Electronic Keyer with three memories and Weight Control, and selection of Full QSK or Semi-break-in operation. For DX-pedition use, a unique Beacon mode allows you to send a repetitive message on, for example, six meters, to help others spot propagation to your location. And if youre looking to upgrade your license class, the CW Trainer feature will send five-character letters and/or numbers via the speaker, so you can practice CW reception when the bands are dead! The FC-40 is a new, wide-range Antenna Coupler for the FT-450, FT-857, and FT-897 Series of Transceivers. The FC-40 is a microprocessor-controlled antenna impedance matching network designed for use with all versions (original and D) of the FT-450, FT-857, and FT-897 HF/VHF/UHF Transceivers. The FC-40 makes use of control circuitry inside the transceiver, allowing the operator to monitor and control operation of the FC-40, which mounts near the antenna feedpoint. Fully waterproof, the FC-40 may be mounted outdoors in exposed locations, and will handle a 100 Watts of transmitter power. He FC-40 is designed for operation on 7 54 MHz, when using an 8 whip like the YAESU YA-007, or on 1.8 54 MHz when used with a random-length wire longer than 66. Matching time is typically five seconds or less, and the required drive power is 4 60 Watts. The FC-40 sports a whopping 200 match-setting-point memories, for instant recall of the tuning settings. The ATAS-25 is a manually-tuned portable antenna system ideal for the FT-817, FT-897, and FT-857 transceivers. Capable of operating on the Amateur bands between 7 MHz and 450 MHz, the ATAS-25 is designed for mounting on a standard 1/4 camera tripod stud (tripod not supplied), and includes an innovative fine-tuning system allowing precise SWR adjustment in the field. Balcony Mount Counterpoise Kit (Base Mount Required). Automatic Antenna Tuner (For coaxial lines). Collins CW Filter 500 Hz, 7-pole. Collins SSB Filter 2.3 kHz, 10-pole. Lightweight Stereo Headset for use with HF transcievers. Temperature-Compensated Crystal Oscillator 0.5 ppm. Ni-MH Battery (FT-897 accepts two). 30A Power Supply 110V. 23 Amp Power Supply 100/200-240 VAC. AC Adapter for CD-24. External Speaker (12 Watt Peak). Desktop External Speaker w/Filter. Amateur Radio \ Brochures \ HF/Satellite Transceivers and Amps FT-897 Brochure. Amateur Radio \ Manuals \ HF/Satellite Transceivers and Amps FC-30 Installation Instructions. SCU-17 USB Interface Unit Instruction Manual. Are the 60-meter frequencies in my FT-897 off frequency? NTIA specifies channels in terms of “channel center” frequencies, where as amateur transceivers, in tuning a commercial channel, typically must be tuned 1.5 kHz lower than the specified “channel center” frequency. For example, for a “channel center” frequency of 5332 kHz, you tune a “traditional” transceiver to 5330.5 kHz. So go ahead and try it. Set up an FT-817ND/857D/897D to the “5332” channel, and tune your FT-1000MP to 5330.5 kHz. Now transmit from the 817ND/857D/897D; you will find that you are precisely on frequency as you monitor on the other transceiver. Note: If you program 5330.5 kHz into a “regular” memory from the VFO, it will be on the same frequency as the “5332 kHz” channel in the special 5 MHz memory bank, as the 60-meter bank (only) displays according to the “channel center” format. The item “Yaesu FT 897D Radio Transceiver BRAND NEW” is in sale since Sunday, December 03, 2017. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The seller is “islomania” and is located in Eatonville, Washington. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, Sweden, South Korea, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Russian federation, Israel, Mexico, New Zealand, Singapore, Switzerland, Norway, Qatar, Croatia, Colombia.
- Bundle Listing: Yes
- Brand: Yaesu
- Model: FT 897D
- Supported Modes: AM
- Type: Base Station