HamGeek Mini-ANT 20W QRP Shortwave Antenna HF Antenna 5MHz-55MHz Full-Band Tuned Antenna Specifications: – Adjustable frequency: 5MHz-55MHz for sending and receiving – VSWR less than 1.5 at 7MHz/10MHz/14MHz/21MHz – Power: 20W – FM 76mhz-108mhz reception – Can receive UHF VHF frequencies. With transmitting assistance funciton – Adjust frequency via its knob; and the band switch selects the short-wave high and low bands – Stretched size 140cm/55.1 (including tuner). Made of stainless steel – Unstretched size around 30cm/11.8 (including tuner). Tuner size 10 x 3 x 3cm/3.9 x 1.2 x 1.2 (LxWxT) – Top with M4 male connector. Output M male or BNC male connector Package Included: – 1 x Tuner – 1 x Antenna. USDR/USDX HF QRP SDR Transceiver SSB/CW Transceiver 8-Band 5W Ham Radio Black Shell With Handheld Mic Description: USDR/uSDX is a pocket-sized 8-band SSB/CW QRP transceiver. Designed with built-in lithium battery, built-in microphone, PTT button and extremely low RX current consumption, it is a good partner for SOTA, POTA or any other portable activities. This QRP SSB/CW shortwave transceiver has a 1602 screen, built-in battery, a charger, built-in microphone and speaker. It can be connected to automatic buttons. It can also CW decoding. Using durable IRF series transmitting tube 2. Can be used to connect to an antenna (instrument base) 3. Aluminum laser shell marking, all aluminum buttons, with translucent silicone buttons 4. The original qcx circuit is greatly simplified, and the installed components are reduced by 50%. No complicated transformer windings. Continuously adjustable in the 160m-10m frequency range (loss of 20khz performance).. 99mhz Open source firmware, built in ide; allows experimentation, can add new functions, can share contributions through github, software complexity: 2000 lines of code V-based software can be used for fast and complete rogue operations (qsk and semi-qsk), or auxiliary execution in digital mode (without cat or ptt interface) for rx/tx switch, with tx/pa delay control external ptt output -Simple installation and modification, 8 component changes and 8 lines Lightweight, low-cost transceiver: Thanks to the eer electronic liquid level transmitter, it has high power efficiency (no need for a huge heat sink) and simple design (no need for complex balanced linear power amplifiers) SSB transmitter phase is completely based on digital and software: control the phase of the si5351 PLL (through small i2c frequency changes over 800kbit/s) and the amplitude of the PA (through pwm to pwm) to test the microphone input and reconstruct the SSB signal. Key shaping circuit PA All-digital and software-based SDR receiver stage (optional): I/Q signal (complex) is sampled from the quadrature sampling detector digital mixer, and perform 90 degree phase shift (Hilber transform) software in it and delete sidebands by adding Three switchable analog controllers independent of the front receiver 0db, -13db, -20db, -33db, -53db, -60db, and -73db Mds receiver noise level: -135dbm (200hz bw) at 28mhz Pre-receiver selectivity: steep frequency adjustment -45db/ ten times roll-off +/- 2khz Blocking dynamic range: 20khz offset 123db, 2khz offset 78db CW decoder, direct/iambic-a/b keying-Vfo a/b + rit and frequency division, and switch the corresponding relay with filter through i2c-Cat support (TS480 subset), which can be streamed through CAT transmission of audio, keystrokes and display text Interface Introduction: Charging: Built-in lithium battery charging port, only use the included charger! It is forbidden to use chargers by other producers Switch: off. Bat: built-in battery power supply. 13.8: external power supply DC13.8v/3a: External power interface Key: Automatic key body connection (a, b, single key) Pa: external power amplifier, ptt signal Mic: External microphone interface Uart: Serial communication (TS-480 compatible command) Spk: external speakers Package Included: 1 x Transceiver 1 x Power Adapter 1 x Mic. 8-Band 5W USDR/USDX HF QRP SDR Transceiver SSB/CW Transceiver w/ HamGeek Mini-ANT Shortwave Antenna. Description: USDR/uSDX is a pocket-sized 8-band SSB/CW QRP transceiver. Key shaping circuit PA All-digital and software-based SDR receiver stage (optional): I/Q signal (complex) is sampled from the quadrature sampling detector digital mixer, and perform 90 degree phase shift (Hilber transform) software in it and delete side-bands by adding Three switchable analog controllers independent of the front receiver 0db, -13db, -20db, -33db, -53db, -60db, and -73db Mds receiver noise level: -135dbm (200hz bw) at 28mhz Pre-receiver selectivity: steep frequency adjustment -45db/ ten times roll-off +/- 2khz Blocking dynamic range: 20khz offset 123db, 2khz offset 78db CW decoder, direct/iambic-a/b keying-Vfo a/b + rit and frequency division, and switch the corresponding relay with filter through i2c-Cat support (TS480 subset), which can be streamed through CAT transmission of audio, keystrokes and display text Interface Introduction: Charging: Built-in lithium battery charging port, only use the included charger! 13.8: external power supply DC13.8v/3a: External power interface Key: Automatic key body connection (a, b, single key) Pa: external power amplifier, ptt signal Mic: External microphone interface Uart: Serial communication (TS-480 compatible command) Spk: external speakers. HamGeek Mini-ANT 20W QRP Shortwave Antenna. Specifications: Adjustable frequency: 5MHz-55MHz for sending and receiving VSWR less than 1.5 at 7MHz/10MHz/14MHz/21MHz Power: 20W FM 76mhz-108mhz reception Can receive UHF VHF frequencies. With transmitting assistance funciton Adjust frequency via its knob; and the band switch selects the short-wave high and low bands Stretched size 140cm/55.1 (including tuner). Made of stainless steel Unstretched size around 30cm/11.8 (including tuner). Tuner size 10 x 3 x 3cm/3.9 x 1.2 x 1.2 (LxWxT) Top with M4 male connector. Output M male or BNC male connector. 1 x Transceiver 1 x Power Adapter 1 x Mic 1 x Tuner 1 x Antenna. Usually it costs about 30USD-50USD. Thanks for your understanding. If you receive the item that not satisfied or defective, please do not open case and kindly notify us within 30 days.
