Apache Labs ANAN-10 SDR 10W HAM Transceiver

Apache Labs ANAN-10 SDR 10W HAM Transceiver
Apache Labs ANAN-10 SDR 10W HAM Transceiver
Apache Labs ANAN-10 SDR 10W HAM Transceiver

Apache Labs ANAN-10 SDR 10W HAM Transceiver
Mouseover image to zoom. Apache Labs ANAN-10 SDR Specifications & Highlights. Continuous, uninterrupted, receive coverage from 10KHz to 55MHz. Supports Real-Time display of entire sectrum from 0-55mHz (with suitable PC software). Supports 7 fully independent receivers (sharing the same antenna – and with suitable PC software). Each receiver can display 48/96/192/384/1152kHz of spectrum. Blocking Dynamic Range (ARRL Method) no detectable gain compression below ADC overload. Transmit and receiver image rejection > 110dB. Full duplex operation, any split over entire 160m to 6m range. Built-in high performance preamp, with a noise floor typically -135dBm in 500Hz. Software-selectable 31dB input attenuator in 1dB steps. Same specifications as the HPSDR Mercury receiver (ie Dynamic Range typically 125dB). FPGA code can be updated via the Industry Standard TCP/IP network Ethernet connection. Seven user-configurable open-collector outputs, independently selectable per band and Tx/Rx (for relay control, etc – with sequencing via PC code). Separate open-collector PTT connection for amplifier control, etc, with sequencer. Microphone PTT jumper-selectable from tip or ring connection. Bias for electret microphones via jumper. Four user-configurable 12 bit analogue inputs (for ALC, SWR etc). Three user-configurable digital inputs (for linear amplifier over temperature, etc). Can operate from a 13.8v DC supply or 12v and 5v supplies. Jumper selected in-built low noise and high efficiency switch mode power supply designed by Kjell Karson, LA2NI? Less than 600mA (receive – one receiver) from a 13.8V supply. I2C bus connector for control of external equipment. Full QSK operation (performance dependant on associated PC and control software). Low-level transmitter output for transverter use via user-selectable output attenuator. Stereo audio outputs at line and headphone levels. In-built 1W stereo audio amplifier for directly driving speakers. Direct, de-bounced connections for a Morse key (straight or iambic) and PTT. Direct ribbon cable interface to Apollo 15W power amplifier, low pass filters and automatic ATU. Industry Standard TCP/IP network Ethernet interface supports static, APIPA or DHCP IP address. Hermes responds to ping and ARP requests and auto senses network connection speed. Eight (8) Layer PCB design for the most professional, state-of-the-art, design available. Custom build rugged Extruded Housing for Hermes and the PA note: no ventilation holes required in. Mosfet 10W Linear amplifier (160M-6M) gives 15-20W out on HF and 10-15W on 6M. LPFs for the PA harmonic suppression and receiver filtering. Software Configurable Triple antenna ports. SWR Bridge, enables Forward and Reverse Power plus SWR to be displayed using suitable PC software. T/R, LPF Switching using mechanical relays (gold plated contacts). Reverse Polarity protection with resettable fuse. All cables, Hardware and instructions to make a complete transceiver with Hermes. Frequently Asked Questions Q. Is an Apache Labs radio right for me? The Apache Labs software defined radios are built and designed for highly technical operators with a moderate amount of computer and networking experience — not appliance users. They are on the cutting edge of radio technology and the radios are continuously improved through user feedback. An Apache Labs radio is right for you if: 1 you are looking for the highest performance and latest technology; 2 you are an experienced radio operator with computer experience; 3 you’re willing to work through the resources provided by the Apache Labs community at Yahoo Groups; and 4 you understand the nature of cutting edge technology includes frequent firmware updates and hardware revisions to stay on the cutting edge and to address issues as they are uncovered. Are Apache Labs radios warrantied and supported just like any other ham radio? Also, since there’s really no interface for this radio aside from third party software, there’s not a whole lot to support. There is a US service center for Apache Labs products should something fail, but most of the time user issues can be resolved with advice from the community, software patches, or firmware updates. Q: What is the difference between the Flex 1500 and the ANAN-10? A: Here are some of the significant differences between those two radios. Flex 1500 has only 1 receiver (48kHz wide). The ANAN-10 has 4 receivers and each receiver can display up to 1152kHz of spectrum! On the Flex 1500, software options are limited to PowerSDR, but the ANAN-10 is open source and there is a lot of software available. The Flex 1500 is based on an older SDR design several generations old while the ANAN 10 is much more current. The ANAN-10 has 3 antenna inputs, versus a single antenna port on the Flex 1500. Flex 1500 mds IS -116 vs ANAN-10 -138. The Flex 1500 uses a USB interface while the ANAN-10 uses a Gigabit ethernet interface. We warrantee and represent that the goods are as described in the above listing. We specifically disclaim any implied warranties of title, merchantability, fitness for a particular purpose and non-infringement. Customers should satisfy themselves that any item choice made is suitable for their intended purpose or use. We pride ourselves on our customer service. Is a full service computer and amateur radio store. Our PC department stocks the latest components for upgrading your PC, building your own PC, or having us build one for you. Our Radio department features the latest products from manufacturers such as Alinco, Icom, Kenwood®, Yaesu, MFJ, Diamond, and many more. Whether you’re a DX’er looking for the latest HF rig or a soon-to-be-HAM looking for study materials and a two-meter handie talkie, we have what you need! We look forward to adding you to our long list of satisfied customers. You may also like. Template by Froo Apps. The item “Apache Labs ANAN-10 SDR 10W HAM Transceiver” is in sale since Monday, October 19, 2015. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The seller is “gigaparts” and is located in United States. This item can be shipped to United States, to Canada, to United Kingdom, DK, RO, SK, BG, CZ, FI, HU, LV, LT, MT, EE, to Australia, GR, PT, CY, SI, to Japan, SE, KR, ZA, TH, to Belgium, to France, to Hong Kong, to Ireland, to Netherlands, PL, to Spain, to Italy, to Germany, to Austria, IL, to Mexico, to New Zealand, SG, to Switzerland, NO, QA, HR, CO.
  • Type: Base Station
  • Brand: Apache Labs
  • Model: ANAN-10
  • MPN: ANAN-10
  • Country/Region of Manufacture: India
  • Frequency Band(s): HF
  • Supported Modes: AM

Apache Labs ANAN-10 SDR 10W HAM Transceiver