For Sale: A mint ICOM-7410 HF-6m Transceiver opened for MARS with both additional roofing filters giving the unit 15 kHZ, 6kHZ and 3 kHZ. The ICOM DSP algorithms are designed to work within these bandpass limits and work quite well. It has less than 2 hours of transmit time and less than 50 hours of receive time on it. It is from a non-smoking environment. The ICOM-7410 is essentially the ICOM-7600 without the real time scope or dual watch. You also can add a real time panadaptor by bringing the IF out to the rear panel. There is a TP socket right near the crystal filters which ICOM Service uses to monitor the IF during testing. You plug a TP cable into that, route it to your rear panel and then run that to either the Elecraft P3 or similar. 0.030 – 60.000 MHz. 1.800 – 2.000 MHz2. 3.500 – 3.999 MHz2. 7.000 – 7.300 MHz2. 10.100 – 10.150 MHz. 14.000 – 14.350 MHz. 18.068 – 18.168 MHz. 21.000 – 21.450 MHz. 24.890 – 24.990 MHz. 28.000 – 29.700 MHz. 50.000 – 54.000 MHz2. 1 Some frequency ranges not guaranteed. 2 Depending on version. Number of Memory Channels: 101. Antenna Connector: SO-239 x 2 [50 ohm]. Usable Temperature Range: -10°C to +60°C; +14°F to +140°F. Frequency Stability: ± 0.5 p. Power Supply Requirement: 13.8 V DC (±15% negative ground). Current Drain (at 13.8 V DC): Transmit max. Receive standby: 2.2A. Maximum audio: 3.0A. Dimensions (approx): 12.4(W) x 4.7(H) x 13.5(D) inches, (315x117x344 mm), (projections not included). Weight (approx): 22.5 lb. 100W HF+50MHz fixed-station transceiver. +30dBm IP3 class receiver circuitry (HF). Dual-conversion receiver with I/Q image-reject mixer (as employed in IC-7600, IC-7700, IC-7800 and IC-9100). 1st IF: 64.455 MHz. 2nd (final) IF: 36 kHz. Standard 15kHz first IF roofing filter, optional 6kHz/3kHz first IF filters max. 32-bit IF-DSP (at 36kHz IF), the same class as used in the IC-7600, and 24-bit ADC. DSP: ADI ADSP-21369 32-bit floating point 333MHz clock Processing power = 2000MFLOPS. CODEC: AKM AK4620B high-performance ADC/DAC. Dynamic range: ADC 113 dB. TCXO master oscillator: ± 5 X 10-7 frequency stability (0 +50°C). Built-in Antenna Tuner(HF/50 MHz) with motorised air-variable tuning capacitors for accurate matching. Rear-panel USB “B” port supporting CI-V and TX/RX baseband, for direct computer interfacing. Supports RS-BA1 Internet remote-control software suite. Band edge beep alarm helps users avoid off-band operation. Integral RTTY demodulator and decoder. Large B/W LCD screen, ergonomically designed controls. Simple band scope (non-real-time). +13.8V DC primary power. Condition: Mint transceiver with very low hours. Unit will be repacked in the original ICOM packaging and include the manuals, the schematics, the Nifty Guide, the 12V power cord and the hand microphone. IT too worked superbly. Contact me if you have any questions. Buyers should note: Unlike the plagued 9100 units whose transverters often required frequent repair, the 7410 units (160-6M) have been trouble free so far as I know. The item “Icom IC 7410 Radio Transceiver Opened for MARS withboth Roofing Filters MINT” is in sale since Tuesday, April 25, 2017. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The seller is “admiral*shin” and is located in Baton Rouge, Louisiana. This item can be shipped to United States.
- Frequency Band(s): HF
- Supported Modes: AM
- Band Plan: MARS
- MPN: IC-7410
- Country/Region of Manufacture: Japan
- Mono/Multi Band: 160 – 6 METERS
- Brand: Icom
- Model: IC 7410
- Type: Base Station