Kenwood TS-430S – HF All-Band Transceiver, Made in Japan. Introduced in 1983, the TS-430S was Kenwood’s first all solid-state HF transceiver and one of the most capable rigs of its era. It covers all amateur bands from 160 through 10 meters including the WARC bands (17m and 12m), with a general coverage receiver spanning 150 kHz to 30 MHz. Power requirement is DC 13.8V at 20A. Features include dual digital VFOs with 10 Hz readout, RIT, IF shift, tunable notch filter, noise blanker, speech processor, VOX, and memory channels. The TS-430S is a well-supported radio with an active community, abundant service documentation, and readily available parts. Made in Japan by Trio-Kenwood Corporation. A rainbow ribbon cable with a DB-25 connector is attached to the rear/top of the unit, consistent with a previous computer or TNC interface installation. Slight dents visible on front panel top left corner; see photos for details. All front panel knobs and buttons present. FM unit appears installed (FM mode button present and labeled). Rainbow ribbon cable/DB-25 interface attached – origin unknown; see photos. Memory backup battery condition unknown – replacement is a routine service item on this model. No power supply or DC power cable included. Country of Manufacture: Japan. Frequency Coverage: 160-10 meters (amateur) + 150 kHz-30 MHz general coverage receive. Power Requirement: DC 13.8V, 20A. FM Unit: Appears installed. Power Supply Included: No. Condition: Used – untested, as-is; dents on front panel top left; see photos.