PortaPack Porta Pack + HackRF One SDR + Case +Antenna 0.5PPM TXCO GPS Simulator. The hackrf one is inlcuded and it is open source and made in china. Havoc Firmware is installed, and you can flash the firmware from the below link. More information you can go to this web. Add a PortaPack H1 to your HackRF One software-defined radio, and leave your laptop behind! The PortaPack H1 attaches to your HackRF and adds a touchscreen LCD, navigation controls, headphone jack, 0.5ppm clock reference, real-time clock, micro SD card slot, and custom aluminum case. Just add a USB battery, and you’re ready to explore radio spectrum wherever you are. The PortaPack firmware runs on the fast ARM processors in your HackRF. No computer is necessary (except for reprogramming firmware). According to source code: github. Com/sharebrained/portapack-hackrf. Redesign this hardware and share it to the enthusiast. Has completed the program validation prototype. The latest 2018.10 month documents are based on improvements. The PortaPack is open-source — hardware and firmware. The source files are published on GitHub. Contributions, forks, and bug reports are welcome! 2.4 inch, 240 x 320 RGB LCD, with touch screen. Four-way arrow keys, rotary jog wheel, and select button. Coin battery for preserving settings and date/time. Micro SD card slot for data and code storage. Wideband (18MHz) spectrum analysis and waterfall. Monitoring of boat (AIS), automobile (TPMS), and utility meter transponders (ITRON ERT). HackRF mode runs HackRF firmware for use with host computer SDR software. PPM calibration for more accurate tuning. Sleep mode saves power by turning off just the display. You may also find the Furrtek HAVOC firmware very interesting! Some assembly is required. The assembly steps are documented in the support wiki and videos. Your HackRF will continue to function with computer-based SDR software, when you put the PortaPack into “HackRF Mode”. PortaPack is compatible only with the HackRF One. It is not compatible with the earlier HackRF Jawbreaker design. If you have an RF shield installed on your HackRF, the PortaPack should fit just fine. Compatibility with the HackRF Blue is experimental. One Blue owner has reported good results with minor mechanical interference between the PortaPack audio capacitors and the baseband header. If your HackRF Blue does not have a baseband header installed, you should have no mechanical problems. PortaPack requires an external battery. Any USB-connected battery should work, though they vary widely in quality and poorly-designed batteries may inject voltage regulator noise into the radio. The PortaPack and HackRF One will not replace your handheld ham radio receiver. Receive sensitivity varies from band to band, but will not perform as well as a true ham radio receiver. Specification of Hackrf one. Operating freq: 1 MHz to 6 GHz. Supported sample rates: 2 Msps to 20 Msps (quadrature). Interface: High Speed USB (with USB Micro-B connector). Power supply: USB bus power. Software-controlled antenna port power (max 50 mA at 3.3 V). SMA female antenna connector (50 ohms). SMA female clock input and output for synchronization. Convenient buttons for programming. Pin headers for expansion. 1 x Finished PortaPack Porta Pack + Hack RF One SDR + Case. 1 x USB cable. We believe our items are so outstanding. All products are quality checked. We will be happy to resolve any issues you may have in a cordial and friendly manner. The item “PortaPack Porta Pack + Hack RF One SDR + Case +Antenna 0.5PPM TXCO GPS Simulator” is in sale since Wednesday, August 7, 2019. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The seller is “saymlove” and is located in Shen Zhen. This item can be shipped worldwide.
- MPN: Does not apply
- Brand: Unbranded
